- This topic has 1 reply, 2 voices, and was last updated 14 years, 10 months ago by
.
-
Topic
-
I am trying to setup my first x12 interface. I can’t seem to get it to work. On our HL7 threads under the inbound tab I use a rawhl7ack, not sure what to put for the x12. Anybody know? I had them sending to my test thread and writing them to a file which worked, however it sent it over and over with no end. Im not sure why it just continued to send to the outbound thread. I setup the actual thread to send to the https recipient and now nothing gets routed. Any help would be appreciated. I have a 14 day temp license to see if the SSL HTTPS will work for us. only 13 days left!!
-
Replies
-
-
What release of Cloverleaf?
I am going to assume 5.6 or later (because that is what I have this working on).
First –
If you are converting an HL/7 to X12 you will need to provide the X12 envelope fields in the message USERDATA via a Tcl proc.
I have a proc that does that. Email me and I will send it to you.
You then will use a provided Tcl proc to build the envelope.
For the HTTPS protocol – are you doing a Post?
In any case, I think (I know for post) you will need to specify a Tcl proc in the HTTPS protocol definition. There is a Cloverleaf provided proc which may serve your purposes – it did not for us.
By the way is this for the UHC 278 project?
Again email me and I will try to get you through this.
email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.
-
- The forum ‘Cloverleaf’ is closed to new topics and replies.
