Shutdown mode in UPoC

[Daniel Lee]

I have an outbound UPoC thread with a UPoc in the Write TPS.  In the “Start” mode I am setting up my handles to a database and in the “Shutdown” mode I am closing the db and cleaning up my handles.  I did some tracing and the Shutdown mode is never getting called.  Is there a reason for this or is something wrong?

using QVDXi 3.8.1P.

Topic

[Ed Mastascusa]

we have exactly the same situation (upoc write, closing the db in shutdown mode) in version 5.1 and the ‘shutdown’ mode switch gets triggered.

Assuming things work in 3.8.1 as they do in 5, is your case “shutdown” in all lower case?

[David Caragay]

Shutdown works fine in our 5.2 environment.

[Anonymous]

It works for us too (5.2)

Of course it only works when the thread is manually stoped. If it is killed or dies it won’t execute that part of the code.

[Daniel Lee]

It is in all lower case.  I put echo statements in and the startup is being called but the shutdown isn’t being called when I stop the thread or shut down the process.  Attached is the UPoC.

[David Caragay]

Are you sure the shutdown process is not being called?  Or maybe the odbc code is not completing correctly.  Remove all code in the shutdown location and replace it with an echo command.  If you run the shutdown with this echo and all looks good (enable_all eo config), slowly add your code back in until you isolate the problem.  I’m not running the odbc add-on in our environment so I can’t check the actual odbc code.

[Author]

Replies