My first got ya!

[Gary Atkinson]

I found out that after you change a thread name in netconfig you better bounce the process afterwards!  I have been testing a results feed for sometime and today I could not get a message outbound.  The messages were testing fine in the testing tool.  Then it dawned on me to check the recovery db and there they were in state 7 with destination of my “old” thread name.  I dumped the messages, restarted process and resent the messages.  What ya know they went out no problem.  So much to learn so little time  😆

Topic

[Nate Kruse]

If that’s your first got ya, you’re batting a better percentage than most of us.   😀   My cherry was popped very early.

[Author]

Replies