Dynamically load tcl code

Homepage Clovertech Forums Read Only Archives Cloverleaf Cloverleaf Dynamically load tcl code

  • Creator
    Topic
  • #51467
    Shibu Mathew
    Participant

    Hi All,

    Is there a way to dynamically make the tcl code changes active, without restarting the process each time. I did  “purge caches” at the thread level, but it did not make my new change active.

    Thank you,

    Shibu Mathew

    Valley Health System, NJ

    Ph: 201-291-6238

Viewing 1 reply thread
  • Author
    Replies
    • #70414
      Jim Kosloskey
      Participant

      You can do this inside the NetMonitor either at the thread (full control) or Process (full control).

      In either case:

       If the proc is new:

          1. click on the ‘reindex’ button

          2. click on the reload button and then in the next dialogue box

              select the proc in question from the pull down. If your proc does not  show up in the pull-down then you did not do the previous step.

        If the proc already existed and you have just modified it:

           1. just do step 2 above.

      email: jim.kosloskey@jim-kosloskey.com

    • #70415
      James Cobane
      Participant

      Shibu,

      Is the tcl code in an Xlate or a tps proc?  If it is a tps proc, you can perform a ‘reload’ on the affected process from NetMonitor.  ‘Purge Cache’ would only affect tcl code within an Xlate.

      Jim Cobane

      Henry Ford Health

Viewing 1 reply thread
  • The forum ‘Cloverleaf’ is closed to new topics and replies.

Forum Statistics

Registered Users
5,041
Forums
28
Topics
9,199
Replies
34,021
Topic Tags
266