- This topic has 4 replies, 3 voices, and was last updated 16 years, 12 months ago by
.
-
Topic
-
-
Replies
-
-
Robert, You cannot cause the ITERATION Action to begin at any specific point. However, for your case, inside the ITERATE you can modify the %f1 counter. I would rather modify my own counter (say %f2) and use that in the address path of the following Actions. That way you would always be able to tell where the ITERATION was as %f1 would have the real value of the iteration count.
You can reference and/or modify iteration counters by prefixing the counter with a $.
Such as a MATH ADD Action where you are trying to add 1 to %f2:
The Source column would have =1 and $%f2.
The Destination column would have $%f2.
You would then use %f2 anywhere appropriate in the Source and/or destination address paths.
Jim Kosloskey
email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.
-
-
Chris, A small but not insignificant change to your IF Action:
IF $%f1 <---- Note the $
🙂 So there you have a couple of ways to resolve your issue one where you just use your own counter and start it with one more than the iteration counter, and one where you utilize an IF Action to detect where in the iteration set you are.
Cloverleaf(R) seems to always provide more than one way to get the job done.
Jim Kosloskey
email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.
-
-
- The forum ‘Cloverleaf’ is closed to new topics and replies.
