Clovertech

ORM TO ADT_04

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › ORM TO ADT_04

  • Creator
    Topic
  • January 5, 2010 at 9:26 pm #51457
    Femina Jaffer
    Participant

      What is the best practice to create an ADT_A04 message from an incoming ORM message?  Tcl or Xlate?

      I created a xlate which works fine in the testing tool; but, when I run this thru the engine it only sends the ORM message and no ADT_A04?

      Thank you,

      Femina

    • Creator
      Topic
    Viewing 1 reply thread
    • Author
      Replies
      • January 5, 2010 at 9:41 pm #70378
        Jim Kosloskey
        Participant

          I would use Xlate.

          In the Xlate I would have an inbound variant and a different outbound variant.

          I would specify the ORM (quite possibly an ORM^O01 in reality) as the message and ADT^A04 in the outbound message type.

          I would NOT use BULKCOPY.

          I would build my Xlate to do what I want.

          I have done this sort of thing before and it always worked properly (once I got my Xlate the way I wanted it) in both the tester and inside the engine.

          Are you running it in the engine in the same site that you tested it in?

          email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.

        • January 5, 2010 at 11:11 pm #70379
          Femina Jaffer
          Participant

            I am running it on the same site.  I will take a look at it again with the tips you have suggested.

            Thank Jim.

        • Author
          Replies
        Viewing 1 reply thread
        • The forum ‘Cloverleaf’ is closed to new topics and replies.