X12 Thread configuration help needed please

This topic has 1 reply, 2 voices, and was last updated 15 years ago by Jim Kosloskey.

Creator

Topic
December 10, 2009 at 12:29 pm #51414
Mike Wilson
Participant
I am trying to setup my first x12 interface. I can’t seem to get it to work. On our HL7 threads under the inbound tab I use a rawhl7ack, not sure what to put for the x12. Anybody know? I had them sending to my test thread and writing them to a file which worked, however it sent it over and over with no end. Im not sure why it just continued to send to the outbound thread. I setup the actual thread to send to the https recipient and now nothing gets routed. Any help would be appreciated. I have a 14 day temp license to see if the SSL HTTPS will work for us. only 13 days left!!
Creator

Topic

Viewing 0 reply threads

Author

Replies
- December 10, 2009 at 2:25 pm #70196
  Jim Kosloskey
  Participant
  What release of Cloverleaf?
  
  I am going to assume 5.6 or later (because that is what I have this working on).
  
  First –
  
  If you are converting an HL/7 to X12 you will need to provide the X12 envelope fields in the message USERDATA via a Tcl proc.
  
  I have a proc that does that. Email me and I will send it to you.
  
  You then will use a provided Tcl proc to build the envelope.
  
  For the HTTPS protocol – are you doing a Post?
  
  In any case, I think (I know for post) you will need to specify a Tcl proc in the HTTPS protocol definition. There is a Cloverleaf provided proc which may serve your purposes – it did not for us.
  
  By the way is this for the UHC 278 project?
  
  Again email me and I will try to get you through this.
  
  email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.
Author

Replies

Viewing 0 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.