Clovertech

X12 help

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › X12 help

  • Creator
    Topic
  • November 23, 2009 at 8:19 pm #51363
    Travis Tuinstra
    Participant

      I am trying set up a connection for 270/271 transactions. In the EO Config: I have enable_all and in the log it shows

      IDLE and 572 bytes but no error: starting READ

      PDL changed states: old 0, new 1

      Calling Tcl procedure: hci_pd.read

      with args: {}

      Tcl procedure hci_pd.read returns ‘RECEIVE’

      trying to match phrase: basic-msg

      ] multi: phrase #0 rejected; trying next

      11/23/2009 14:04:19

      no-match: no more phrases to try

      I assume there is something set up wrong, but am at a loss as to what. This is our first X12 transaction set. Can someone give me a few pointers as to what to look for?

    • Creator
      Topic
    Viewing 0 reply threads
    • Author
      Replies
      • November 23, 2009 at 8:37 pm #69892
        Jim Kosloskey
        Participant

          What protocol is the sending system using?

          If you set this up like HL/7 and used mlp-pdl, then I think that is your problem.

          When I have done real-time X12 it is usually TCP/IP. The X12 community does not have the mlp specification.

          What does your Companion Guide from the sending system indicate?

          In the log take a look at the hex dump of the message (it appears you are using a PDL protocol) I suspect it does not have whatever encapsulation you are expecting.

          email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.

      • Author
        Replies
      Viewing 0 reply threads
      • The forum ‘Cloverleaf’ is closed to new topics and replies.