Clovertech

unknown segment

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › unknown segment

  • Creator
    Topic
  • March 24, 2009 at 2:12 pm #50744
    Mike Delahunt
    Participant

      Hello All,

      (we are running cloverleaf version 5.5)

      I am building an new interface where the inbound thread is setup with a Trx id Format of ‘HL7’.  I also created a new variant because the sending application is sending multiple Z segment.  When I turn the interface on and view the process level error log I am recieving the following errors:

      msg :RecP:WARN/0:rev_fsl_adt_ib:03/24/2009 09:35:33] [0.0.3] unknown segment ‘ZE1’ — ignored.

      [msg :RecP:WARN/0:rev_fsl_adt_ib:03/24/2009 09:35:33] [0.0.3] unknown segment ‘ZE2’ — ignored.

      These segment are properly created in the variant but the Trx id setting on the inbound thread does not allow me to define which variant I want to use.  Could someone tell me what I’m missing?

      Thanks in advance!

      Mike

    • Creator
      Topic
    Viewing 3 reply threads
    • Author
      Replies
      • March 24, 2009 at 2:25 pm #67333
        Anonymous
        Participant

          The place where these needs to be defined is in your Translation file.

          First take the message into the tester using your Variant to make sure that works. Then run it through the translation test.

          If you don’t get the errors there then you will not get them in the engine.

          Make sure when you define your translation to use your new variant.

        • March 24, 2009 at 3:02 pm #67334
          Mike Delahunt
          Participant

            Hello John,

            I ran both the variant and the xlate in the tester using the inbound message and both worked with no errors.  I shutdown the site and performed a site clean up, started everything back up and the errors still show up in the process error log.  Any other idea’s?  I can send print screen if that would help.  I must be missing something simple.

            Thanks again,

            Mike

          • March 24, 2009 at 3:41 pm #67335
            Max Drown (Infor)
            Keymaster

              Those errors are generated by the xlate (not trx). Make sure you have configured the xlate to use the variant you created (the one that includes the Z segments).

              Note that by default trx pulls the value from MSH.09 and uses that value to determine the routes. It pretty much ignores the rest of the message.

              -- Max Drown (Infor)

            • March 24, 2009 at 6:30 pm #67336
              Mike Delahunt
              Participant

                I want to thank all of you that replied to my dilemma!!  We have a create_ack tcl proc on our inbound tps that requires arguments to define what variant you want to use.  Once I put in the correct variant the errors went away, I knew it had to be something simple.  Thanks again, you guys/gals are the best!

                Mike

            • Author
              Replies
            Viewing 3 reply threads
            • The forum ‘Cloverleaf’ is closed to new topics and replies.