Clovertech

Bidirectional Tables….

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › Bidirectional Tables….

  • Creator
    Topic
  • June 27, 2008 at 7:44 pm #50138
    Tom Rioux
    Participant

      I’m on 5.2 and the bidirectional table I am testing with doesn’t appear to work from out to in.   I do have the bidirectional box checked and I have chosen “output” within the translate.  However, it won’t return anything, not even my default I have entered.

      Has anyone had problems with this?

      Thanks…

      Tom Rioux

    • Creator
      Topic
    Viewing 1 reply thread
    • Author
      Replies
      • June 27, 2008 at 8:16 pm #65002
        Jim Kosloskey
        Participant

          Tom,

          We are also on Cloverleaf(R) 5.2.

          I just tested it and it works fine for me, I also tested looking for an entry that does not exist and I got the appropriate default.

          email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.

        • June 30, 2008 at 1:19 pm #65003
          Tom Rioux
          Participant

            I found the issue that was causing the problem.  I downloaded a script off of Clovertech that creates tables.  I was calling that script from a cron job.  The files that it was acting upon were CSV files that have each entry pair on a new line.  I didn’t think to look for a carriage return at the end of each line.  So, whenever I ran the script, the table would work fine from “in to out” but not “out to in”.   If I opened the table in the GUI and did any kind of modification, it would stirp out the carriage return and the table would work fine in both directions.  So, I simply just added a entry to the script that would strip out the carriage return as I read in each line.

            Thanks…

            Tom Rioux

        • Author
          Replies
        Viewing 1 reply thread
        • The forum ‘Cloverleaf’ is closed to new topics and replies.