[Sebastien Bazile]

Thank you Jim I will try that in the a.m.

[Sebastien Bazile]

Thank you everyone for all your help. There was an issue with the file. I did hcihexdump like you said and found out the segments were ending with 0xa instead of oxd. fixed it and now testing working out great. Thanks again gentlemen.

[Sebastien Bazile]

Thank you so much. Didn’t think about that.

[Sebastien Bazile]

I’m still just getting the MSH segment when I ran it through the HL7 tester.

[Sebastien Bazile]

That I haven’t done. I will try it tonight and see what I get. Thanks a lot.

[Sebastien Bazile]

yes, I just don’t know what’s going on. I used PATHCOPY too, same thing.

[Sebastien Bazile]

Thank you Jim and Charlie. Charlie, you were right, it was the file I was using. It now works perfectly. Thank you so much gentlemen.

[Sebastien Bazile]

I am still getting just the MSH SEGMENT. There might be something wrong with the late tool itself. I don’t know. Is there a way I can do this in TCL?

[Sebastien Bazile]

I tried that but only getting the MSH header.

[Sebastien Bazile]

Right now, the MSH-3 field is empty and the vendor wants me to add “ADT” in field 3. I don’t have a working xlate so I can’t do a bulkcopy. So the only way I can do it is by writing a tcl proc and I’m not that knowledgeable.

thank you

[Sebastien Bazile]

I want to put ADT in MSH.3

[Sebastien Bazile]

thanks for replying. but I’m not that knowledgeable with xlate. could you please a bit more specific. perhaps a few steps. Just started learning cloverleaf.

thank you.

[Sebastien Bazile]

is that after I do a pathcopy?  thanks.

[Sebastien Bazile]

It’s number 1.

I have multiple obx segment but only want to sent 1 through 10 and suppress anything after that. Please help.

thank you.

[Sebastien Bazile]

I went with your guys ideas but only getting partial of the message with the pathcopy.

For Exam:

MESSAGE 1

[0:TEST] Illegal pathcopy from “0(0).OBX(0)” (segment) to “0(0).OBX” (segment with automatic iteration).

0(0).MSH(0)  :  >|^~&|||||||ADT^A08||P|2.4<

0(0).EVN(0)  :  >|A08<

0(0).PID(0)  :  ><

0(0).PV1(0)  :  ><

thank you.

[Author]

Replies