[Mike Thompson]

😀 Happy to report with the help of Jim I have come to a solution that meets my needs!  Here are results:

Here are the results for RGS iterate:

Set temp counter : copy =0  -> $%g99

Set iterate:  segment PRE_PROCEDURE  %s1

Copy action under iterate:  use basis on all inbound, in this case I am usinga VRL segments

i.e. PROCEDURE(%s1).SEQUENCE_NO

Now the trick figure out where the basis group should go for temp counter.  Since this is a group iterate it needs to go in the very first counter:  

2(%g99).0(0).RGS(0) ,#1

So copy action goes -> (%s1) to repeat group -> (%g99)

Close iterate with the following:

Math Add 1

=1 -> $%g99

This will set the next group to repeat.  

Results below:

2(0).0(0).RGS(0)  :  >|1|1<

2(0).1(0).0(0).AIS(0)  :  >|1|1|

2(0).2(0).0(0).AIG(0)  :  >|1|1|

2(0).3(0).0(0).AIL(0)  :  >|1|1|

2(0).4(0).0(0).AIP(0)  :  >|1|1|

2(1).0(0).RGS(0)  :  >|2|2<

2(1).1(0).0(0).AIS(0)  :  >|2|2|

2(1).2(0).0(0).AIG(0)  :  >|2|2|

2(1).3(0).0(0).AIL(0)  :  >|2|2|

2(1).4(0).0(0).AIP(0)  :  >|2|2

2(2).0(0).RGS(0)  :  >|3|3<

2(2).1(0).0(0).AIS(0)  :  >|3|3|

2(2).2(0).0(0).AIG(0)  :  >|3|3|

2(2).3(0).0(0).AIL(0)  :  >|3|3|

2(2).4(0).0(0).AIP(0)  :  >|3|3|

Again many thanks to Jim Kosloskey on this one!

Mike

[Mike Thompson]

Yes, I was surprised to not see anything posted on Clovertech on RGS grouping already.  The way I understand the standard this should be a common requirement.  Perhaps I do not understand chapter 10 correctly?

Thanks,

Mike

[Mike Thompson]

Yes, both defined as repeating.  Repeat is set on the group and on the RGS segement itself.  I tried changing this grouping mutiple times with no luck.

Thanks,

Mike

[Author]

Replies