[Mark Rilling]

Ed,  THX for the tip!  Using IF is better than nothing, but I hope they add a REM in feature versions.

[Mark Rilling]

I have been trying to use the exec below in an alert, but it dosent seem to work.  I set up a duplicate alert to just notify and I get the messages on the screen when my que gets to the settings.  I just can’t get the thread to cycle.

exec hcicmd -p process -c ‘thread pstop’;hcicmd -p process -c ‘thread pstart’

[Mark Rilling]

Rick,

This is a new test server and, no I have never been able to open the IDE.  Its on a 2000 server and I’m logging as the local administrator.  QDX service has started.  and hciss says its running.

[Mark Rilling]

Rick,

Yes it is, I am working directly on that PC.  The QDX service is running

[Mark Rilling]

Hello,

I have a problem similar to this, the process stays UP (dosent go to OPENING) but the transactions stop going out.  A netstat on the recieving system shows 2 espablished connections from QDX to the same port on the recieving system, but QDX only shows 1 connection.  It’s like the recieving side never got the message to drop the old connection, but it started up the new one.

Any ideas would be appreciated

[Mark Rilling]

THX again for the help.  The ( ) seemed to be required, as it did not work w/o them.    Any suggestions on the best way to block unpopulated OBX segments (no value in field 5) and re-number the remaining OBX so they are sequencial?

[Mark Rilling]

I’ll give it a try

Thank you!

[Author]

Replies