Clovertech | james tey | Activity https://clovertech.infor.com/members/james-tey/activity/ Activity feed for james tey. Mon, 20 Apr 2026 14:51:09 -0400 https://buddypress.org/?v= en-US 30 hourly 2 0dd92934ff4d5cb5960ad6731b026446 james tey replied to the topic connection established but unable to recieve any messages in the forum Cloverleaf https://usspvlclovertch2.infor.com/forums/topic/connection-established-but-unable-to-recieve-any-messages/#post-81621 Sat, 22 Nov 2014 19:43:30 -0500

Charlie Bursell wrote:
Turn up the EO. If TCP/IP MLP it is probably not properly wrapped

Thanks.
Just want to be sure, it’ the sender’s mlp not wrapped properly?

]]> 0 12c863c79c0026ebb00ca3e338550135 james tey replied to the topic Running out of semephores in the forum Cloverleaf https://usspvlclovertch2.infor.com/forums/topic/running-out-of-semephores/#post-60254 Sun, 24 May 2009 07:22:43 -0400 Thanks David.

I’ve hit the exact same error when starting the 2nd test site monitor daemon (1st site monitor daemon started without any errors)

I switch the site and try, yet the same error occurs.

Nothing else was done but just adding the extra setting as listed by David after the 1st testing was done that shows the error. Rebooted Solaris and…Read more

]]> 0 cc4fcc1c9190653c591b593b3a798928 james tey replied to the topic Running out of semephores in the forum Cloverleaf https://usspvlclovertch2.infor.com/forums/topic/running-out-of-semephores/#post-60252 Fri, 22 May 2009 03:31:02 -0400

Bill Bertera wrote:
Does HP/UX use the /etc/system settings? On Solaris, you have to define the amount of available semaphores in that file. Look for stuff like this:

* Cloverleaf Interface Engine Requirements
set semsys:seminfo_semmap=2050
set semsys:seminfo_semaem=16384
set semsys:seminfo_semmnu=2048
set pt_cnt = 1024
set…Read more

]]> 0