[Abhishek]

Hi Jerry, There are no other entries other than broken pipe. Could you please let me know the way to increase the logging level to view other entries ? Thanks ! I appreciate your assistance

[Abhishek]

Hi Jerry, Thanks for your response. Connection appears to be fine and vendor port is also reachable via telnet. However when source system sends us message that contains embedded pdf in OBX-5.5, this is getting stuck on state 11 (On OB post- TPS queue). The OB Thread status shows Broken pipe.

Does length of OBX-5.5 affect the interface ?

In Test environment the length of one such test message was 551,433. In prod environment, length is coming around 364,252 but still causing the broken pipe issue.

This issue was never encountered in test environment. Please help !

[Abhishek]

Thanks for answering Jeff. Could you also let me know the way to increase the max files configuration and if this could cause any issue with other interfaces in PROD ?

[Abhishek]

This worked, Thanks a lot Travis !

-AJ

[Abhishek]

Hi Travis,

I am getting TCL callout error while using this line of code in the Xlate either in pre proc or post proc.

I am new to cloverleaf and dont understand this completely. Can you assist where I should use the code

xlateStrTrimLeft A

xlateStrSubstring 1 end

 

Thanks

AJ

[Abhishek]

Hi Jim,

Yes, I have beginner level training. I am trying to scale up by developing interfaces and learning on the go, and would require technical documentations.

Please let me know if you can help me with this.

Thanks

-AJ

[Author]

Replies