Clovertech

Translates not translating 100% of the time

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › Translates not translating 100% of the time

  • Creator
    Topic
  • July 22, 2010 at 7:06 pm #51882
    marcus robinson
    Participant

      I have created 12 translates and for some reason two of them do not translate 100% of the time.  I don’t find any errors in the log and the non translated messages are being passed to the receiving system, where of course they error.  Has anyone experienced this before?  If so what is the fix.

      Thanks!

    • Creator
      Topic
    Viewing 2 reply threads
    • Author
      Replies
      • July 26, 2010 at 11:04 am #72126
        Robert Kersemakers
        Participant

          Hi Marcus,

          No, I haven’t seen anything like that.

          If there are no errors in the error log then Cloverleaf finds no errors and it is doing what it’s told. So either there is something wrong in your configuration (NetConfig) or the translations are not translating the message in a certain situation. Can you recreate this by putting the inbound messages through the translation in the testingtool? If these work fine, then there is something wrong in your configuration.

          Hope this helps!

          Zuyderland Medisch Centrum; Heerlen/Sittard; The Netherlands

        • July 26, 2010 at 5:54 pm #72127
          marcus robinson
          Participant

            I think I figured it out.  I have a Raw route that appears to have been the culprit.

          • July 26, 2010 at 7:06 pm #72128
            Jim Kosloskey
            Participant

              Marcus,

              That would do it!!

              email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.

          • Author
            Replies
          Viewing 2 reply threads
          • The forum ‘Cloverleaf’ is closed to new topics and replies.