Clovertech

Simple x12 Interface

› Clovertech Forums › Cloverleaf › Simple x12 Interface

Tagged: 

  • Creator
    Topic
  • June 12, 2019 at 5:34 pm #109478
    Brent Phillips
    Participant

      Hey all,

      I’m attempting our first x12 interface, a simple Inbound/Outbound arrangement with a raw route, and was hoping I could get some input on the “default” way to set this up. I have connectivity between systems, but can’t seem to get the message to do anything on the inbound side.

      If anyone has an end-to-end setup guide for an x12 interface in Cloverleaf (6.2) I would very much like to see it.

      Thank you!
      Brent Phillips

    • Creator
      Topic
    Viewing 1 reply thread
    • Author
      Replies
      • June 13, 2019 at 10:02 am #109484
        Jim Kosloskey
        Participant

          What is your IB Protocol? How are the messages encapsulated? Are they length encoded or ???.

          email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.

        • June 19, 2019 at 9:13 am #109794
          Dustin Sayes
          Participant

            Following up on Jim’s direction… if unsure of the payload, enable all info on the process log and it will give a hex dump of inbound data. Hope this helps..

        • Author
          Replies
        Viewing 1 reply thread
        • You must be logged in to reply to this topic.