Quovadx platform 5.5 – HL7 2.2 —> 2.5

Clovertech Forums Read Only Archives Cloverleaf Cloverleaf Quovadx platform 5.5 – HL7 2.2 —> 2.5

  • Creator
    Topic
  • #49351
    Femina Jaffer
    Participant

      Can the latest version of quavadx platform 5.5,  take an HL7 2.2 record and translate it to HL7 2.5 before sending?

      Thank you.

      fj

    Viewing 6 reply threads
    • Author
      Replies
      • #61605
        Jim Kosloskey
        Participant

          Femina,

          Check to see if you can define HL/7 2.2 snd 2.5 variants via the HL/7 configurator.

          If you can define the variants, then no problem.

          If there is one you cannot define, then you can still make it work. You will need to define the variant as a version you do have and then change the definition to as closely as possible match the version required. Then change the version number in the Xlate if it is the outbound variant.

          Jim Kosloskey

          email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.

        • #61606
          Femina Jaffer
          Participant

            hi Jim,

            We do not have 5.5 installed as yet.  But, this question was asked by a potential customer.  Anyway, if I could check the HL7 configurator I would, but as we do not have this installed as yet, I was hoping someone may have the answer to this.

            Thanks fj.

          • #61607
            Jim Kosloskey
            Participant

              Femina,

              Check the 5.5 Rease Notes in the Documentation Topic of this forum.

              Jim Kosloskey

              email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.

            • #61608
              Robert Kersemakers
              Participant

                Hi Femina,

                We have 5.5 installed and HL7 2.5 is supported.

                It is possible though to send HL7 2.5 in 5.2: make a 2.4 variant and redefine the changed segments. The only problem here is that some 2.5 types are not available; I replaced these types by String and made sure the correct components were send in the translation.

                Zuyderland Medisch Centrum; Heerlen/Sittard; The Netherlands

              • #61609
                Femina Jaffer
                Participant

                  Thank you so much Robert.  Much appreciated.

                  Femina

                • #61610
                  sanjay suri
                  Participant

                    Robert Kersemakers wrote:

                    Hi Femina,

                    We have 5.5 installed and HL7 2.5 is supported.

                    It is possible though to send HL7 2.5 in 5.2: make a 2.4 variant and redefine the changed segments. The only problem here is that some 2.5 types are not available; I replaced these types by String and made sure the correct components were send in the translation.

                    We recently upgraded to 5.5 Rev1 and yes you can easily configure 2.2 to go out as 2.5.   Just make sure required fields are populated going outbound.

                  • #61611
                    Femina Jaffer
                    Participant

                      Thanks Sanjay, that was the answer we were hoping for!

                      Thanks again for your response.

                      Femina

                  Viewing 6 reply threads
                  • The forum ‘Cloverleaf’ is closed to new topics and replies.