Clovertech

No routes defined for TrxId DFT_P03

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › No routes defined for TrxId DFT_P03

  • Creator
    Topic
  • June 27, 2005 at 6:57 pm #47862
    Doug Stelley
    Participant

      I’ve tried routing DFT_P03 raw as well as an out of the box (wild card route ) same error.

      opening the failed messages in SMAT, they seem OK.

      What is the matter?

      win2K 3.8.1P rev6

      Thanks in advance…

      Doug

    • Creator
      Topic
    Viewing 2 reply threads
    • Author
      Replies
      • June 27, 2005 at 9:02 pm #56929
        Joe Halbrook
        Participant

          Hi Doug,

          I always start with the most obvious first. (And I’ve done these before.)  ðŸ˜¯

          Check that your route is DFT_P03 (zero 3) and not DFT_PO3 (letter O 3).

          Also, your MSH.1 has an extra in it.  Not sure if that’s your formatting or the actual content.

          Joe

        • June 28, 2005 at 4:57 pm #56930
          Anonymous
          Participant

            And another classic that I do is to forget to tell the thread these are going to be HL7 messages.  Check transaction id determination to make sure it’s not set to fixed.

          • June 29, 2005 at 12:36 pm #56931
            Doug Stelley
            Participant

              I think I found it. This was a new Thread in a new process in a new interface project.

              It wasn’t the most obvious answer but I should have caught it. I made a new Variant, but didn’t make a DFT_P03 message type, so, no routes.

              DOHHHH

              Thanks all

          • Author
            Replies
          Viewing 2 reply threads
          • The forum ‘Cloverleaf’ is closed to new topics and replies.