Clovertech

Messages stuck in State 7 – How to send these messages

› Clovertech Forums › Read Only Archives › Cloverleaf › General › Messages stuck in State 7 – How to send these messages

  • Creator
    Topic
  • September 20, 2005 at 3:03 pm #48045
    LeeAnne Kardas
    Participant

      I have a outbound interface in up status with messages in State 7 in the recovery database.  How do I send these State 7 Messages.

      Thanks, Lee Anne 203-789-5955

    • Creator
      Topic
    Viewing 0 reply threads
    • Author
      Replies
      • September 21, 2005 at 4:03 pm #57444
        Anonymous
        Participant

          Hi Lee Anne,

          Do you suspect the messages are stuck in state 7?  The only reason that this could normally happen is if the messages were processed through translation while the outbound (OB) thread was off, the OB thread was renamed and then turned on.

          Take a look at the database dump of those messages and see if the destination thread name exactly matches the actual thread name in the NetConfig.

          If you want to resend those messages then dump them into a file (using ‘hcidbdump’) and then resend the messages using the network monitor.

      • Author
        Replies
      Viewing 0 reply threads
      • The forum ‘General’ is closed to new topics and replies.