Linux backend command line to "complile" xlates

This topic has 5 replies, 2 voices, and was last updated 14 years, 6 months ago by Ronald Ortiz.

Creator

Topic
April 13, 2011 at 2:10 pm #52406
Ronald Ortiz
Participant
Does anyone know of the backend command line to compile an xlate? I have about 40 xlates that we’re moving into PROD and the only way I know how to compile them is via the GUI by opening the xlate, clicking compile and open the next xlate. This takes way to long. I’d rather run a command.

Thanks,

-Ron
Creator

Topic

Viewing 4 reply threads

Author

Replies
- April 13, 2011 at 5:55 pm #74072
  Charlie Bursell
  Participant
  hcixlttest
  
  If no errors nothing returned
- April 20, 2011 at 7:53 pm #74073
  Ronald Ortiz
  Participant
  ~~Charlie Bursell wrote:~~
  
  hcixlttest
  
  If no errors nothing returned
  
  Thanks! Not sure how I never noticed that!?! 😳
- April 20, 2011 at 8:04 pm #74074
  Ronald Ortiz
  Participant
  ~~Charlie Bursell wrote:~~
  
  hcixlttest
  
  If no errors nothing returned
  
  Hmm…so how do I get it to display an error if something is wrong? I compiled and when it’s fine it displays nothing…so I assume it’s fine. But I manually tweaked the xlate to cause an error so see what it looks like in the backend…and it shows nothing. So how would I know if there’s an error?
- April 20, 2011 at 8:09 pm #74075
  Charlie Bursell
  Participant
  If there is an error you will see it. It is the same as executing compile at the GUI
- April 20, 2011 at 8:13 pm #74076
  Ronald Ortiz
  Participant
  ~~Charlie Bursell wrote:~~
  
  If there is an error you will see it.
Author

Replies

Viewing 4 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.