how to add hex codes to a message

This topic has 1 reply, 2 voices, and was last updated 13 years, 9 months ago by David Barr.

Creator

Topic
March 21, 2011 at 10:30 pm #52363
Cynthia Briscoe
Participant
We have a vendor who is requesting that each lab result hl7 message end with a hex code of 1c which I understand is a file separator code. Currently our lab system send a 0d or carriage return. How would one go about “adding” that in an xlate or is that even possible?
Creator

Topic

Viewing 0 reply threads

Author

Replies
- March 21, 2011 at 11:54 pm #73933
  David Barr
  Participant
  Is this a TCP/IP interface? If you use the pdl-tcpip protocol with the mlp_tcp PDL driver, it should add the necessary characters for you. 0x1C is a byte that is part of HL7’s “minimal lower layer protocol”.
Author

Replies

Viewing 0 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.