Clovertech

error 300 Xlate config file unloadable

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › error 300 Xlate config file unloadable

  • Creator
    Topic
  • February 12, 2011 at 12:55 am #52268
    Cynthia Briscoe
    Participant

      I have a translation that works fine on the testing tool and is currently in use in our live interface engine.  It does not work in the test engine.  The threads are set up the same, the xlate is the same, but I keep getting this error.  I have copied the Xlate from the live environment over the test just to make sure there wasn’t something I was missing between live and test, cycled the process and threads but still get the same message.  I am stuck.  Does anyone have any clues as to why this will not work?

    • Creator
      Topic
    Viewing 4 reply threads
    • Author
      Replies
      • February 12, 2011 at 1:47 am #73633
        Jim Kosloskey
        Participant

          Make sure the Xlate referenced variants/formats can be located.

          email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.

        • February 12, 2011 at 5:11 pm #73634
          Keith McLeod
          Participant

            I  usually will run File–> Compile on the saved Xlate to flush out any issues.  You may want to try this to confirm that you have none with the Xlate.

          • February 14, 2011 at 8:56 am #73635
            Robert Kersemakers
            Participant

              And make sure you have all the tables that are mentioned in the Xlate as well.

              Zuyderland Medisch Centrum; Heerlen/Sittard; The Netherlands

            • February 14, 2011 at 5:28 pm #73636
              Cynthia Briscoe
              Participant

                Thank you all for your input.  Since I had this thread routing to 5 different systems, the xlate in question wasn’t even the one I was testing but on the first routing and you were correct, a table was missing! thank you, thank you all!

              • February 14, 2011 at 5:50 pm #73637
                Keith McLeod
                Participant

                  FYI.. Compile as a practice.  It will tell you that the table was not found.  It helps to remind me if I miss something.  Good luck….

              • Author
                Replies
              Viewing 4 reply threads
              • The forum ‘Cloverleaf’ is closed to new topics and replies.