Epic to SMS ADT

This topic has 3 replies, 2 voices, and was last updated 13 years, 4 months ago by James Cobane.

Creator

Topic
May 17, 2011 at 6:56 pm #52486

Kirby Knight
Participant

We are trying to send ADT from Epic to SMS. The first message we send has the correct REGION CODE, HOSPITAL CODE, AND SMS ID. But each subsequent message does not. Has anyone seen this issue before?
Creator

Topic

Viewing 2 reply threads

Author

Replies
- May 18, 2011 at 1:58 pm #74424
  
  Kirby Knight
  Participant
  
  We have been able to get messages to post to Invision. It seems as if the first message works and than subsequent messages get jumbled up.
- May 18, 2011 at 6:28 pm #74425
  
  Kirby Knight
  Participant
  
  We can resend the same message multiple times without issue. When we restart the outbound thread, than try to send a message, the interface sends a bunch of small messages that make no sense.
  
  To fix this we have to adjust the sequence number in Invision (SMS) and restart the interface.
- May 18, 2011 at 6:53 pm #74426
  
  James Cobane
  Participant
  
  Kirby,
  
  I suspect the “small” messages that are being sent are the “3STRT” messages that INVISION expects upon startup of the RTIF interface. This messaging handshake is usually done via some pre-write procs (within RTIF.tcl) that were developed by the Cloverleaf folks to facilitate interfacing with INVISION.
  
  Jim Cobane
  
  Henry Ford Health
Author

Replies

Viewing 2 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.