Clovertech

batch processing

› Clovertech Forums › Cloverleaf › batch processing

  • Creator
    Topic
  • May 12, 2020 at 10:48 am #116748
    Ryan Curtin
    Participant

      I’m batch processing data from SMAT I am noticing that the larger the recovery database grows, the slower the processing of data becomes and so I was wondering if there is a way to halt data that is in state 5 from processing to state 7. To allow for current state 7 data to process through to state 11?

    • Creator
      Topic
    Viewing 0 reply threads
    • Author
      Replies
      • May 12, 2020 at 11:17 am #116749
        Jim Kosloskey
        Participant

          Are you doing a resend of the SMAT extracted data or extracting to a file then using a Fileset Protocol thread?

          If you extract to a file, then use a Fileset Protocol thread, you can control the arrival rate thus lessening the impact on the Engine.

          That said I try to not process batch integrations and real time integrations in the same site.

          I am not sure if there is any way to control the flow if doing a resend.

          email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.

      • Author
        Replies
      Viewing 0 reply threads
      • You must be logged in to reply to this topic.