attaching xlate to thread

This topic has 4 replies, 3 voices, and was last updated 14 years, 10 months ago by Robert Kersemakers.

Creator

Topic
February 18, 2010 at 4:26 pm #51580
gricelda lopez
Participant
Hello,

So i created my first xlate and i tested it out and my results were good (during testing). When I attached it the my thread in netconfig and resend messages my xlate doesnt work.

It doesnt apply my copyies for msh-4 or 5 … am I suppose to somehow activate my xlate?
Creator

Topic

Viewing 3 reply threads

Author

Replies
- February 18, 2010 at 4:36 pm #70837
  Jim Kosloskey
  Participant
  If you did not stop and then start the process, the route specification changes did not get loaded into memory.
  
  email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.
- February 18, 2010 at 6:48 pm #70838
  gricelda lopez
  Participant
  ok, i didnt do that.
  
  Will do. thanks!
- February 18, 2010 at 6:55 pm #70839
  gricelda lopez
  Participant
  It worked! woo hoo!
  
  Thank you soo much.
- February 19, 2010 at 8:50 am #70840
  Robert Kersemakers
  Participant
  Congratulations with your first Xlate!! 😀
  
  Zuyderland Medisch Centrum; Heerlen/Sittard; The Netherlands
Author

Replies

Viewing 3 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.