Reply To: McKesson Series Transmit Error

Clovertech Forums Read Only Archives Cloverleaf General McKesson Series Transmit Error Reply To: McKesson Series Transmit Error

#59298
Dave Zibble
Participant

    Your mnemonic is ITCFM,  7 screens back…. We are not setup this way in production,  however, I tried flipping the bolded parms to Yes on our test box and bouncing.  I expected to have the transmit error out when I stopped the thread on the engine.  It did.  Then after the inbound on the engine was Up I expected the transmit to start up on its own.  It never did.  I think I might run this by McKesson since they are here this week for 11.0 upgrade training.  If I learn something I’ll post it here.

    Transmit/Extract Options:                                Page 1        

                                                                         

    Extended transaction logging  . . . . . . . . . . . . . Y   (Y/N)    

    Auto start transmit/extract in the Nightly Job Stream . Y   (Y/N)    

    Auto restart transmit from the extract program  . . . . N   (Y/N)

    Auto restart extract from the transmit program  . . . . N   (Y/N)    

    Sleep time after all records have been transmitted  . .  20 (seconds)

    Number of negative acknowledges before error  . . . . .  5  (times)  

    Transmit job name prefix  . . . . . . . . . . . . . . . QDX          

    Auto restart on timeout/NAK limit error . . . . . . . . N   (Y/N/P)

    Wait time for acknowledgement . . . . . . . . . . . . . 15  (seconds)

    Transmit STAT orders before non-STAT orders . . . . . . Y   (Y/N)    

    Send cancel code on order cancel transactions . . . . . Y   (Y/N)