Homepage › Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › Unable to open up Gui/network monitor after failover › Reply To: Unable to open up Gui/network monitor after failover
Has anyone had a similar problem? We just went through a controlled fail-over on AIX 6.1 tl2 running Cloverleaf 5.8.4. We had to fail-back without performing the maintenance we wanted to.
Our setup is active/active, meaning that we have two physical servers, one Live, one Test, the hci software filesystem is local to each server, and it contains links pointing to the sites directories, which are located in another file system that fails over.
The symptoms are the same (after we looked back later) – everything failed over successfully and quickly except that the monitor would not start. We tried to start it manually several times but each time we got:
[pti :sign:WARN/0:_hcimonitord_:04/15/2013 13:03:22] Thread 0 ( _hcimonitord_ ) received signal 11
[pti :sign:WARN/0:_hcimonitord_:04/15/2013 13:03:22] PC = 0xd41f7e44
We were failing over the production system to the test server. The test server was slightly different than the production server in that a master site was defined in the test server, and that we had installed cis6.0 on the test server only.
Does anyone have HACMP with one side having a master site, and the other side not having a master site? Where does the master site configuration get stored, and is that taken into consideration in the HACMP / profile scripts?
The last fail-over worked fine in all regards was done before we setup a master site and before we installed cis6.0.
Peter
Peter Heggie