Reply To: Joint messages

[Michael Hertel]

The target system may not be able to respond in 10 seconds so the engine will resend the message again. Therefore if the target system had not read the first message, it could have two messages in it’s buffer and that would be what’s causing this problem. You might even have to change the timeout to something higher than 30.

Could you email me a copy of your recover33 proc file?

I want to read the header of the file where it tells you how

to configure your interface. Also, I’d like to see what these procs are doing.

I believe you need a validation proc for the reply message and

I believe your “TPS Inbound reply” configuration needs tweaking.

You can email to pgmmjh@vmmc.org

Thanks,

-mh