One received message two messages sent

This topic has 2 replies, 2 voices, and was last updated 6 years, 11 months ago by Robert Berrios.

Creator

Topic
October 31, 2017 at 3:22 pm #55544

Robert Berrios
Participant

I have a charge interface where “CH” and “CR” are sent in the same message. The receiver wants to receive two separate messages. One message for the “CH”s and another message for the “CR”s. Using xlate, I am able to send the first message which are for the “CH”s. I then use the SEND statement to send the second message. In order to re-populate the FT1 segment I use @null to clear the segment via an iteration. Afterwards, I iterate on the FT1 segment again selecting only the “CR”s. However, the end result looks like this:

FT1

FT1

FT1|1|……|CR|…………..

No matter what I do I cannot get rid of the first two FT1s.

Any insights will be greatly appreciated.
Creator

Topic

Viewing 1 reply thread

Author

Replies
- October 31, 2017 at 3:37 pm #85702
  
  Jim Kosloskey
  Participant
  
  Are you using your own ITERATE counter for the outbound references for the CR segments? That is a counter % something that you created and you maintain?
  
  Something like %s99 or %g99?
  
  If this is not clear feel free to email me.
  
  email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.
- November 3, 2017 at 2:57 pm #85703
  
  Robert Berrios
  Participant
  
  Thank you for responding.
  
  However, I found out what my issue was.
  
  The FT1 segment is configured as required in the variant.
  
  Thus, in spite of the fact, I was clearing out each field out with @null, it was still reflecting:
  
  FT1
  
  FT1
  
  Once, one makes FT1 optional, the issue is resolved.
Author

Replies

Viewing 1 reply thread

The forum ‘General’ is closed to new topics and replies.