Inter-site routing, messages get stuck

Cloverleaf 6.1.x on both Linux and Windows 2012

Seems like I have an inter-site problem and hope someone can

point me in the right direction

The setup is simple, one thread reads from the disk, sends it to an intersite thread.

On Site B there’s one thread listening and sends it to the next thread that

writes it to the disk

The setup works OK, I sends messages through as expectet.

If I stop the thread or the process that is listening (Site B),

the message stays in the recoverey db (State 7) on Site A, as expected.

When I start the thread / proc on Site B, the message is received

on Site B. So far so good.

If I stop the thread / proc on Site B, sends a message from Site A,

it will be in recovery db (State 7) as before. Now if I stop

the proc on Site A and start it again, I then got two messages in the

recovery db. When I start the proc on Site B, the “new” messages is send

to Site B, but the “old” message is still in the recovery db on Site A

Anyone experinced something like this, appreciate any help

/Torfinn

KMD, Denmark