- This topic has 9 replies, 3 voices, and was last updated 9 years, 4 months ago by
.
-
Topic
-
Hello, I built this translation and have had a couple of coworkers look at this. We can not understand why the last NTE segment is not translating over. Any ideas? I have attached an image of the translation.
Incoming Message:
MSH
PID
ORC|RE
OBR|1|
OBX|1|ST|3631^Testosterone, Free, S||14|ng/dL|9-30||||F||||||||201505131030
NTE|1|L|
NTE|2|L|
ADDITIONAL INFORMATION
NTE|3|L|Testing performed by Equilibrium Dialysis.
OBX|2|ST|8533^Testosterone, Total, S||410|ng/dL|240-950||||F||||||||201505131030
NTE|1|L|
NTE|2|L|
ADDITIONAL INFORMATION
NTE|3|L|Testing performed by Liquid Chromatography-Tandem Mass
NTE|4|L|Spectrometry (LC-MS/MS).
Outgoing Message:
MSH
PID
ORC|RE
OBR|1|
OBX|1|ST|3631^Testosterone, Free, S||14|ng/dL|9-30||||F||||||||201505131030
NTE|1|L|
NTE|2|L|
ADDITIONAL INFORMATION
NTE|3|L|Testing performed by Equilibrium Dialysis.
OBX|2|ST|8533^Testosterone, Total, S||410|ng/dL|240-950||||F||||||||201505131030
NTE|1|L|
NTE|2|L|
ADDITIONAL INFORMATION
NTE|3|L|Testing performed by Liquid Chromatography-Tandem Mass
-
Replies
-
-
Is your result from the Testing tool or from an engine run?
If from an engine run make sure there is nothing post Xlate which might truncate the message.
I cannnot see your Basis for each of the ITERATES but assuming they are correct I do not see anything that jumps out at me.
email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.
-
-
-
In you nested bases, you may need to include your % variables
1 using group variable %g1
1(%g1).0(0).NTE using segment variable %s1
1(%g1).1 using group variable %g2
1(%g1).1(%g2).NTE using segment variable %s3
I think these are what you were using….
You may want to test the message in the HL7 tester using both inbound variant and verify the paths… Then take the same message and test with the outbaound variant to confirm where the counters are counting….
-
-
-
-
-
-
- The forum ‘Cloverleaf’ is closed to new topics and replies.
