InterThread Routing? How to Stop…

This topic has 4 replies, 3 voices, and was last updated 11 years, 6 months ago by chas werner.

Creator

Topic
May 23, 2013 at 8:49 pm #53669
chas werner
Participant
I am new to Cloverleaf but have found this forum very valuable! My issue is that I have created a route between two threads, the first is an incoming thread the second is an outgoing thread. My issue is that in my outgoing thread SMAT file I see a message from the incoming thread( Good 🙂 ) but also occasionally see the same message being sent from the outgoing thread to itself (bad 🙁 ). Has anyone else seen this issue? It is hosing up the queue as the message that is being inter thread sent is not getting an ack as it is to itself. I have already checked the routes for the outbound thread and there are none. Solutions?
Creator

Topic

Viewing 3 reply threads

Author

Replies
- May 23, 2013 at 10:50 pm #78499
  David Barr
  Participant
  Are you trying to route replies from the second system back to the first?
  
  If not then you might need to set the outbound thread to “outbound only”.
- May 30, 2013 at 3:33 pm #78500
  chas werner
  Participant
  That is correct. I am trying to route replies/acks (specifically AAs) back into cloverleaf.
- June 4, 2013 at 9:42 pm #78501
  Robert Milfajt
  Participant
  Anytime the outgoing thread has to resend a message to the destination, you will see this. Cases where this could happen: thread is bounced after message send and before ack received, message sent and ack not received and you have it set up to wait replies and resend if fail.
  
  Other case too I’m sure, but what you are seeing is normal and not a problem.
  
  Hope this helps,
  
  Robert Milfajt
  Northwestern Medicine
  Chicago, IL
- June 11, 2013 at 2:12 pm #78502
  chas werner
  Participant
  It does very much. Thanks for the explanation.
Author

Replies

Viewing 3 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.