Sunquest NTE is being dropped

Tim,

I suspect that your Xlate is not iter’ing through all of the NTE’s and PATHCOPYing them to the outbound message.

Tim,

Make sure your variant has the NTE as repeating and that the Xlate is set up to get and pass all repeitions.

Then check to make sure there is no post Xlate TPS or Outbound Tps procs that might modify the message.

If you turn the EO up all the way you can track the message as it traverses the engine and thus note where the NTE segments get dropped allowing you to focus in.

I don’t think the problem has to do with the format of the inbound messag.

I have also found that removing the end (0) after the NTE also helps if you are just doing a pathcopy of all of the NTEs within a repeating group.

example:

use

pathcopy 1(%g1).0(0).NTE –> 1(%g1).0(0).NTE

instead of

pathcopy 1(%g1).0(0).NTE(0) –> 1(%g1).0(0).NTE(0)

This usually copies all of the NTEs of that group without using the segment iteration.  I use the segment iteration if I am making unique changes to the NTE’s.