Clovertech

Threads per Procees Name

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › Threads per Procees Name

  • Creator
    Topic
  • August 8, 2012 at 8:26 pm #53231
    Corey Lewis
    Participant

      Good Afternoon,

      Is there a “recommened” number of threads that should be attached to a process?  We are converting interface engines and have been putting all of our threads under one process name.  It was suggested to us that we only have 8-10 threads per process.  I am wondering if that is a Cloverleaf recommendation or best for performance or if it doesn’t really matter?

      Thanks

      Corey

    • Creator
      Topic
    Viewing 2 reply threads
    • Author
      Replies
      • August 10, 2012 at 5:18 pm #76986
        Gary Atkinson
        Participant

          I think it depends on our your volume and complexity of intergration.  We break out threads into mulitple process for performance reasons.

        • August 13, 2012 at 7:52 am #76987
          Robert Kersemakers
          Participant

            As Gary says: depends on volume, complexity, your hardware. I try not to put more than 12-15 threads in a process.

            Zuyderland Medisch Centrum; Heerlen/Sittard; The Netherlands

          • August 17, 2012 at 3:35 pm #76988
            Michael Lacriola
            Participant

              I got 30 in one of mine and working fine. However, I would not recommend that and we are looking at ways to minimize.

              Some of the threads in that process are extremely low volume, and we do have 16Gb of memory on our box. Stopping/restarting process takes less than a minute.

              Like I said, I would not recommend it.

          • Author
            Replies
          Viewing 2 reply threads
          • The forum ‘Cloverleaf’ is closed to new topics and replies.