Inbound Message Configuration

This topic has 5 replies, 2 voices, and was last updated 12 years, 10 months ago by James Cobane.

Creator

Topic
February 16, 2012 at 7:08 pm #52942
Chuck Busch
Participant
I am having some trouble with threads remaining in an “Up” state but having to cycle them constantly to get messages to flow. My Host system is ConnectR. My network guys are telling my that ConnectR is intitiating a conversation with PWIM but PWIM is failing to send a response. I have a feeling that I do not have my inbound thread configured properly. I am attaching a screen shot.
Creator

Topic

Viewing 4 reply threads

Author

Replies
- February 16, 2012 at 7:15 pm #76010
  Chuck Busch
  Participant
  Here is the outbound thread
- February 16, 2012 at 7:19 pm #76011
  Chuck Busch
  Participant
  I am confused about the use of the “Outbound Only” check box in the inbound tab.
- February 16, 2012 at 8:14 pm #76012
  James Cobane
  Participant
  Chuck,
  
  The outbound only checkbox configures the thread so that if something comes into the thread when it is not awaiting a reply, it will ignore it. Typically, without this checked, if a message comes into the thread (i.e. an ACK that came after the timeout period) the engine would assume it is inbound data and try to route it, which would then hit the error database.
  
  Hope this helps.
  
  Jim Cobane
  
  Henry Ford Health
- February 16, 2012 at 8:46 pm #76013
  Chuck Busch
  Participant
  So I should have the “Outbound Only” checked on inbound threads, is that correct?
- February 17, 2012 at 12:58 am #76014
  James Cobane
  Participant
  Chuck,
  
  No, you would only check the ‘outbound only’ for an outbound thread.
Author

Replies

Viewing 4 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.