Clone a message stream and change one value

This topic has 1 reply, 2 voices, and was last updated 13 years, 9 months ago by Jim Kosloskey.

Creator

Topic
March 9, 2011 at 5:42 pm #52326
Tom Arrowsmith
Participant
Hi,

I have a project where I need to output three copies of the same message – just with the MSH-4 value being changed. The MSH-4 would direct the same message to 3 different facilities.

Is there a way to do this without actually setting up three different routes?

Thanks!
Creator

Topic

Viewing 0 reply threads

Author

Replies
- March 9, 2011 at 6:08 pm #73819
  Jim Kosloskey
  Participant
  Tom,
  
  If all the mesages are to go to the same OB destination you only need 1 route,
  
  Then inside your Xlate (assuming Xlate here) do a CONTINUE for each outbound message you want with the MSH-4 changed. Don’t forget to do a SUPPRESS at the beginning of your Xlate.
  
  email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.
Author

Replies

Viewing 0 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.