SMAT File will not update

This topic has 4 replies, 3 voices, and was last updated 14 years, 5 months ago by Ariba Jones.

Creator

Topic
July 16, 2010 at 4:40 pm #51873
Ariba Jones
Participant
I did a cycle save on one of my outbound threads in order to look at the messages that were sent out from Cloverleaf. However, when I look in SMAT, it does not show me the files. I continue to get the last set of SMAT files (from two months ago) loaded.

I put in a new translation and am trying to see if it is working properly. I know files have gone through this thread because they have been received on the receiving side.
Creator

Topic

Viewing 3 reply threads

Author

Replies
- July 16, 2010 at 4:45 pm #72090
  Tom Rioux
  Participant
  Kinda simple question…but when you did your cycle save, did you specify “out” for your data direction?
  
  Tom
- July 18, 2010 at 9:40 pm #72091
  Ariba Jones
  Participant
  Tom,
  
  Yes. I did specify ‘out’ for the direction. 😀
  
  I look at SMAT files when testing all the time. It is just strange to me that this one is not working properly. I made sure the file system was not full and it is not. I don’t know what else to look at.
  
  Ariba
- July 18, 2010 at 10:21 pm #72092
  Russ Ross
  Participant
  Check to make sure no other threads defined in the NetConfig are using the same SMAT file by accident, which typically happens when copying a thread and overlooking to change the SMAT file so it is unique in that site.
  
  Russ Ross
  RussRoss318@gmail.com
- July 23, 2010 at 2:05 pm #72093
  Ariba Jones
  Participant
  I got it to work.
  
  I stopped the process, removed the existing SMAT files and then started the process again. When I did the cycle save it worked.
  
  Thanks for your responses!
Author

Replies

Viewing 3 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.