Validation o f message id in MSA

This topic has 3 replies, 3 voices, and was last updated 14 years, 5 months ago by Virginia Everett.

Creator

Topic
March 31, 2010 at 12:20 pm #51663

Virginia Everett
Participant

Has anyone added validation of the message id of the MSA to the message id of the outbound message in the check_ack proc? If so what was the code you used and how long has it been in place?
Creator

Topic

Viewing 2 reply threads

Author

Replies
- March 31, 2010 at 12:47 pm #71169
  
  Jim Kosloskey
  Participant
  
  Virginia,
  
  Do you mean validating the MSH-10 (Control-ID) and do you mean of the Acknowledgment being generated or the message being acknowledged?
  
  email: jim.kosloskey@jim-kosloskey.com 29+ years Cloverleaf, 59 years IT - old fart.
- March 31, 2010 at 1:53 pm #71170
  
  Charlie Bursell
  Participant
  
  If using 5.6+
  
  A copy of the message that is awaiting reply is in OBMSGID. It would be a simple matter to pull MSH.10 from that message and compare to Msg ID in MSA.
  
  We don’t usually feel that is necessary because we don’t send another message until we get ACK for the pending message. Therefore, there should be no queued up messages on the receiving side.
  
  However, the hooks are there for whatever you wnat o do. Just be sure and clean up to prevent memory leaks
- March 31, 2010 at 7:49 pm #71171
  
  Virginia Everett
  Participant
  
  Thanks Charlie that was what I was thinking of.
Author

Replies

Viewing 2 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.