Clovertech

purge process cache via command line

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › purge process cache via command line

  • Creator
    Topic
  • September 4, 2009 at 1:14 pm #51172
    Gary Atkinson
    Participant

      What is the command syntax to run via the command line?  If I do this via the gui network monitor, the hold site gets cached (5.5 bug?)

      thx,Gary

    • Creator
      Topic
    Viewing 3 reply threads
    • Author
      Replies
      • September 4, 2009 at 5:48 pm #69034
        James Cobane
        Participant

          Gary,

          Purging caches takes place at the process level; so it shouldn’t impact the whole site, but it sounds like you are experiencing that.  To purge cache from the command line:

          hcicmd -p processname -c “threadname1,threadname2,threadname3 purgex”

          where the threadnames are all the threads in process ‘processname’

          Hope this helps.

          Jim Cobane

          Henry Ford Heatlh

        • September 4, 2009 at 6:04 pm #69035
          Gary Atkinson
          Participant

            Is there syntax where you don’t have to put the thread names in?

          • September 4, 2009 at 10:29 pm #69036
            Charlie Bursell
            Participant

              Jim:

              I think you have the snytax wrong.  You purge cache at the process level

              hcicmd -p -c “. purgex”

            • September 4, 2009 at 11:30 pm #69037
              James Cobane
              Participant

                Thanks, Charlie.  I thought there was a shorter version, but when I executed a purge cache via NetMonitor at the process level (and displayed the ‘Command Output’), the command it ran used the syntax I posted.

                Interesting….

            • Author
              Replies
            Viewing 3 reply threads
            • The forum ‘Cloverleaf’ is closed to new topics and replies.