HOW TO SETUP ANE MULTI SERVER

This topic has 1 reply, 2 voices, and was last updated 15 years, 10 months ago by Bob Richardson.

Creator

Topic
February 26, 2009 at 4:58 pm #50664
Hongle Sun
Participant
how to set up a mutil server to an inbound thread, how to define the paramters? and where can i find the doc for mutlserver setup configure thanks
Creator

Topic

Viewing 0 reply threads

Author

Replies
- February 26, 2009 at 7:11 pm #67030
  Bob Richardson
  Participant
  Greetings,
  
  I have attached a Word document that describes how to configure a server multi-connection in Cloverleaf. At the time we were running CIS5.3 Rev3 on AIX5.2. The document ought to be fine for Cloverleaf Integrator versions beyond 5.3. Also: do not forget that if you will be sending back ACKS, you need to add the following lines to your ACK/NAK procedure: (the TCP/IP subport off the main port value is contained within the DRIVERCTL):
  
  #For multi-connect servers get/set the tcp local port
  
  msgmetaset $ack_mh DRIVERCTL [msgmetaget $mh DRIVERCTL]
  
  Good luck!
  
  BobR
Author

Replies

Viewing 0 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.