Yet another question re: OBX segments out of order

I have an “MDM_T04” HL7 message that I am getting the following error message “The #4 segment encountered ‘OBX’ is out of order for the message type ‘MDM_T04’. Segment ignored”.

I searched and read the posts already on Clovertech and tried to make sure I have already addressed the issues that most commonly cause this.

– I have made sure that I have all the segments in my inbound message defined in my variant (MSH, EVN, PID, PV1, TXA, OBX)

– I have made sure the variant is defined and in the proper place.

– I ran the inbound message through the HL7 tester and the message went through the tester just fine.

– I went back into my inbound variant and made sure there were no fields marked as “required” on any of the segments.

– I went in to “Reconfigure” and made sure I was using the correct variant.

Here is the actual error message:

MESSAGE 1

[0:TEST] [mid:0x9bc3c4] The # 4 segment encountered ‘OBX’ is out of order for message type ‘MDM_T04’.  Segment ignored.

0(0).MSH(0)  :  >|^~&|LinkLogic-INVT|INVT001^AHG|CECC|AHG|20070531143300.0000-0500||MDM^T04|1496241180154670|P|2.3|||NE|NE< 0(0).EVN(0)  :  >|T04|20070531143300.0000-0500< 0(0).PID(0)  :  >|1|AHG9999|17037-INVT001|9999|Test*^Abner^B||19450717103100.0000-0500|F||U|c/o Noel Stillman^904 Autumn Road, Suite 500^Little Rock^AR^72211^USA||501-202-4300|501-202-4300|||||555-55-5555< 0(0).PV1(0)  :  >< Any suggestions that I haven’t already tried would be greatly appreciated. Thanks, Ricci