Routing addtitional ORU

This topic has 4 replies, 3 voices, and was last updated 18 years, 4 months ago by Robert Kersemakers.

Creator

Topic
September 28, 2006 at 9:53 pm #48808
Mark Perschbacher
Participant
I am trying to put together a config. that will take all inbound ORU’s, read the trix ID, route it out the approiate thread to the foreign host, duplicate all the messages, and route them back an existing outbound thread to another host. I know this can be done with a tcl proc, but can it be done with an xlate?
Creator

Topic

Viewing 3 reply threads

Author

Replies
- September 29, 2006 at 11:16 am #59781
  Scott Lee
  Participant
  Mark,
  
  It sounds like you are making it more complicated than it needs to be. Can you just add a second route for that trxId in the routes tab?
  
  Scott
- October 2, 2006 at 2:39 pm #59782
  Mark Perschbacher
  Participant
  For that to work, as I understand the Route Message functionality, I would have to set up the new route with a trixid, and then insert that id into all the messages, overwriting the original trixid. If that would work, you may have answered my question. The basic strategy here is for all the ORU’s to go our their respective routes, then a duplicate of all these ORU’s sent to a single internal host.
- October 2, 2006 at 4:09 pm #59783
  Scott Lee
  Participant
  I don’t think you need to change the trxId. Just add the new route detail in the route messages tab under each of your current routes defined for the ORU trxIds.
- October 3, 2006 at 7:30 am #59784
  Robert Kersemakers
  Participant
  Or use just one detail and route the message to both destinations.
  
  Zuyderland Medisch Centrum; Heerlen/Sittard; The Netherlands
Author

Replies

Viewing 3 reply threads

The forum ‘Cloverleaf’ is closed to new topics and replies.