Clovertech

Default value for a Copy Command????

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › Default value for a Copy Command????

  • Creator
    Topic
  • August 2, 2006 at 7:21 pm #48682
    Anonymous
    Participant

      In the translator, the COPY command has a place for a default value.

      I would like to have a default value copied to the outbound value if the inbound value is null.

      No matter how I configure it, I can’t get it to work that way. The documentation says it should work.

      What’s up?

      Karl Fisher

      HealthVision

      Irving, Texas

    • Creator
      Topic
    Viewing 2 reply threads
    • Author
      Replies
      • August 2, 2006 at 7:27 pm #59385
        Bill Bertera
        Participant

          karlfisher wrote:

          In the translator, the COPY command has a place for a default value.

          I would like to have a default value copied to the outbound value if the inbound value is null.

          No matter how I configure it, I can’t get it to work that way. The documentation says it should work.

          What’s up?

          Karl Fisher

          HealthVision

          Irving, Texas

          what version are you on? I remember trying to get this working a while back on 3.8 and earlier and it never would work for me either. I haven’t tried since going to 5.2.1. So I don’t know if its been fixed in a release somewhere.

        • August 2, 2006 at 7:30 pm #59386
          Aaron Beckett
          Participant

            Its not working in 5.3 Rev2

          • August 2, 2006 at 7:45 pm #59387
            Aaron Beckett
            Participant

              Its not working in 5.3 Rev3 either. There must be more to it than just selecting from the default drop down. Does anyone have any ideas?

          • Author
            Replies
          Viewing 2 reply threads
          • The forum ‘Cloverleaf’ is closed to new topics and replies.