Clovertech

Member of Multiple Groups in Quoavdx 5.3

› Clovertech Forums › Read Only Archives › Cloverleaf › Cloverleaf › Member of Multiple Groups in Quoavdx 5.3

  • Creator
    Topic
  • May 5, 2005 at 11:40 am #47719
    Keith McLeod
    Participant

      In prior versions one could use groups to view a particular group of threads. Multiple groups could be assigned to an inidividual thread.  For example  I might have a thread belong to inbound, charges, and star.  I can make use of this in tcl code, however the selection in view threads by does not handle group membership when multiple groups are assigned to a thread. This can be seen in the network configuration tool.  Anybody have the same experience.  Any solutions?

    • Creator
      Topic
    Viewing 1 reply thread
    • Author
      Replies
      • May 19, 2005 at 1:20 pm #56538
        David Caragay
        Participant

          Previously I played around with groups but ran into some issues.  I believe the groups would show up correctly if I defined them when I created the thread but if I went back in and made changes, the changes would not be reflected in Netmonitor.  I spoke with the cloverleaf folks and was told there were still some issues they needed to work out.  Looks like they left in the option to add groups in QDX5.2 but the display in Netmonitor does not allow you to see the groupings.

          Maybe an alternative to using groups would be to set up different views in netmonitor.  If you wanted to access the “inbound” view within you tcl, you should be able to read the monitor_dflt.mvw file to pull any required view and/or thread information.  Like most Cloverleaf files, this is simply in a list format.

        • May 25, 2005 at 3:34 pm #56539
          James Cobane
          Participant

            I have seen the issue that Dave is describing also.

        • Author
          Replies
        Viewing 1 reply thread
        • The forum ‘Cloverleaf’ is closed to new topics and replies.