Clovertech

ORU to MDM message

› Clovertech Forums › Cloverleaf › ORU to MDM message

  • Creator
    Topic
  • March 10, 2020 at 3:30 pm #115885
    Mark Brown
    Participant

      I asked about this a few months back and then the project went to the back burner. I have a couple problems with what I have so far.  When running the xlate, it’s picking up the OBX segments, but it’s repeating blank MSH, EVN, PID, PV1, and TXA segments between each iteration of OBX.

      I copy the MSH, EVN, PID and PV1 before the ITERATE where I copy the OBX segments.

      What should I look for as the problem?

       

      The second problem is I’m not sure how to populate the TXA segment in the MDM or do I need to?

      Running Windows server 2016 and Cloverleaf 6.2

      Thanks

    • Creator
      Topic
    Viewing 1 reply thread
    • Author
      Replies
      • March 11, 2020 at 2:17 am #115891
        Charlie Bursell
        Participant

          Where is the iterate in the Xlate?  Perhaps a post of your Xlate file would help.

          For the TXA segment, that would be up to the message receiver.  Does he need it?

        • March 11, 2020 at 3:47 am #115893
          Vince Angulo
          Participant

            Populating the TXA would depend on the requirements of the receiving system — MDMs are very different depending on the vendor, so it’s hard to say.

            As for the iterate, it sounds like the basis for the iteration is the whole message (path = 0), but you only have OBX tasks within the iterate — and it’s outputting blank segments because they’re required, but there’s no tasks to populate them.  The basis path should be 0(0).OBX or something close to that dependent on your HL7 variant.

            Hope this helps — or someone smarter chimes in!

        • Author
          Replies
        Viewing 1 reply thread
        • You must be logged in to reply to this topic.